EZ Computer Help.Org

This is a great video on How to replace your iPhone 4 battery. Just watch the steps and you will be all charged up with a new longer lasting battery.

Before disassembling your iPhone, be sure your iPhone is powered off and the silent switch is on.

1. Locate and eject the sim card.

2. Hold your iPhone on the end to locate two small screws on either side of the dock port. Remove the two 3.6 mm Phillips screws next to the dock connector.

3. Push the rear panel toward the top edge of the iPhone. Remove the rear panel from the iPhone.

4. Remove the single 2.5 mm Phillips screw securing the battery connector to the logic board.

5. Use an iPod tool to carefully pry the battery connector up from the ends closest to the top and bottom edges of the iPhone.

6. Remove the antenna contact from the iPhone.

7.Use the clear plastic pull tab to lift the battery out of the iPhone. Remove the battery.

Click the link below for the new post.

Read carefully everything and you will be able to jailbreak.

first of all download these software’s

Redsnow 0.9.5b2 to jailbreak iphone os4:

http://fileups.net/16Wa1

Download latest itunes setup released on 16th April

Download cydia

http://fileups.net/16WA8

Download pawnage tool:

http://fileups.net/16s984

How TO Download :

Just Fill The Surveys and Get The Download Link

The iPhone Dev-Team is back! They have just released a version of redsn0w 0.9.5b2 to jailbreak the latest iPhone OS 4 Beta
This release is targeted towards developers only to help them upgrade their existing app on Cydia for this upcoming latest

firmware.

The following step by step guide will help you jailbreak your iPhone 3G ONLY on iPhone OS 4 Beta.

Step 1: Download iPhone OS 4 Beta for iPhone 3G.

Step 2: Update to this latest firmware file: iPhone1,2_4.0_8A230m_Restore.ipsw

Step 3: Start redsn0w 0.9.5 and point it to the original iPhone OS 4 Beta firmware for iPhone 3G to proceed.

Step 4: Now select Install Cydia and click Next.

Step 5: Now make sure your device is both OFF and PLUGGED IN to the computer before you click Next.

Step 6: Connect your device in recovery mode by pressing the Power and buttons continuously.

At this stage you will be presented with a screen where you will have to quickly hold Power button and then while
holding the Power button, you will now have to hold Home button too. Now after few seconds release Power button but

keep holding Home button until installation begins.

Step 7: Sit back and enjoy while redsn0w will do all the rest for you. Once done, your iPhone 3G will restart
automatically and you will find it jailbroken with iPhone firmware version 4.0.

Related stuff. try it cool:

Download links:
Blackrain:

http://fileups.net/16s985

forecast-1.1:

http://fileups.net/16s986

Thanks to MobilityToday for one of the frist videos on the iPad 3g 64gb.

This works for both iPhones. As well as any iPhone running any software also doesn’t have to be jailbroken.